Where the money and the material in a robot come from
Whether a robot can be delivered, and whether delivering it makes money, is usually decided less by how well it is built than by where its materials come from and which link binds. This section takes cost structure and key-component sourcing apart separately, with an evidence grade on every figure.
This was a separate procurement research site, Robot Sourcebook (robotsourcebook.com). It merged into this site in November 2026; old addresses redirect here automatically and nothing was dropped.
Five pieces
Cost structure
Humanoid bill of materials
Actuators take 40-60% of hardware BOM, and the gearbox takes 30-50% of a single actuator. BOM per unit: $30,000-$150,000.
Sourcing judgement
Should you substitute a domestic harmonic drive
30-50% cheaper per unit, about a third of the life. Per operating hour it costs more - unless replacement is free and downtime is painless.
Sources and constraints
The semiconductor supply chain behind a robot
Most chips in a robot are mature-node. The binding constraint is power device capacity cycles and lead time, not leading-edge controls.
Selection judgement
Choosing a controller: ESP32 is a family
The classic part, S2, C3 and S3 differ on Bluetooth, USB, DAC, Ethernet and camera support. Three of those are present-or-absent, not fast-or-slow.
Method
Method and evidence grades
How A, B and C are defined, how far each can be used, and four steps to verify any figure yourself.
How to use these pages
Three situations: showing a supplier the cost structure, working out which questions to put to them, and checking a judgement against someone else's. Every page stands alone when lifted out - ranges rather than single points, conflicts published rather than reconciled, and a last-verified date on each.
Related
Last updated 2026-10-09.